Day 29 - Adding a radius to the fretboard and fitting the frets

I put chalk on the fretboard before sanding so that I would be able to see when the radius is complete and then I sanded the fretboard with a 20-inch-radiused sanding block.

I smoothed the fretboard with finer sandpaper.

I filed a bevel into the fret grooves to make it easier to fit the fret wire into the grooves.

I measured and cut sections of fret wire.

I hammered in the frets and clipped off the excess fret wire.

I used a heavy clamp to reduce vibrations when hammering in the upper frets.