Day 16 - Glue lattice to soundboard and make remaining soundboard braces

I cut a piece of 5mm plywood the same size as the lattice.

I marked out the lattice on the plywood so that when i glued it I would be able to see where the pressure should be applied.

I glued the lattice to the soundboard in the go deck, using the plywood to protect the lattice.

I made the harmonic bar braces using the disk sander and the radiused sanding board.

I planed the braces to 7mm thick.

I measured and traced the positions of the braces on the soundboard.

I made the strengthening piece for under the fretboard.

I glued the remaining braces to the soundboard.